Handmade Reversible Welders Cap
100% Pre-Washed Pre-Shrunk Cotton Material.
Not just worn by Welders, but Construction Workers, Painters, Bikers, Machinist, Plumbers and Many More.
My Reversible Welders Caps have No Cardboard in the Bill, so the Hat keeps it's shape. Machine Wash in COLD WATER, Hang Dry.
STEP 1 Select your Crown Height
Crown Height (from 6 1/2" to 7 1/2" high) If Crown Height is not given a 7 1/2 will be made.
To obtain this, measure from the center of your scalp to the area where
the hat will be worn (i.e. if you prefer to wear the cap over your ears
measure to where you would like the cap to sit.)
STEP 2 Select your Hat Size in Inches
Hat Size in Inches - I Just need your Head size/Dimension (i.e. 22 1/2" up to 26" around) You can do this by using a soft tape or a piece of yarn, measure above your Eyebrows and all the way around your Head. REMEMBER to allow additional room if you prefer to wear your Cap over your ears.
Please do not pull tape or yarn tight as you will need it to slide on and off your head with ease.
Hat
sizes vary from company to company, please do not assume your hat size,
take a quick moment to measure your head based on the instructions
above. Thank You
Hat Size |
7 |
7 1/8 |
7 1/4 |
7 1/2 |
7 5/8 |
7 3/4 |
8 |
8 1/8 |
8 1/4 |
Head Circumference (Inches) |
22 |
22 1/2 |
23 |
23 1/2 |
24 |
24 1/2 |
25 |
25 1/2 |
26 |
If you have any questions about obtaining the correct measurements, please do not hesitate to contact me.
STEP 3 Choose Monogramming
Monogramming is available on all caps up to 10 letters for $3.00, additional letters are $.25 each.
STEP 4 Choose fabric(s)
**PLEASE NOTE - IF YOU SELECT MORE THAN 1 FABRIC CHOICE AT A TIME, YOU WILL NEED TO ADJUST THE "ADD TO CART TOTAL" BEFORE PLACING YOUR ORDER!!!
This product was added to our catalog on Friday 23 May, 2008.